Treehouse Cityguide

Login | Register | 中文 | DE/FR



User login

Who's new

Routine maintenance work of VSI's new sand making machine

Joined: 2018-06-22
Points: 0
*Posted: Submitted by crushermachine2 (0) on Sat, 2018-08-11 03:23. | Subject: Routine maintenance work of VSI's new sand making machine

Maintenance lubrication is very important for mechanical equipment. As the most advanced sand making equipment, VSI's new sand making machine is more convenient than the traditional sanding machine and sand making machine. Below we will give you a detailed introduction to the maintenance and maintenance of the VSI sand making machine.

Pay attention to the following nine points during our usual maintenance:

1. Open the observation door before each boot to see the internal parts of the machine and see if the coupling is loose. If it is found to be loose, it should be tightened in time.

2. Check the rotation direction of the rotor before starting the machine. When the direction is reversed, adjust the position of any two wires in the three-phase line of the motor so that the direction of rotation of the rotor is the same as the direction of the arrow on the equipment.

3, equipment feeding should be continuous and uniform, not for a long time, to prevent blockage of the machine.

4. The bolts of all parts of the machine must be fastened and reliable. If it is loose, it should be tightened and then turned on.

5. The pre-tightening force of the V-belt should be adjusted properly. The length of each belt should be as similar as possible to ensure uniform force on the V-belt.

6. VSI's new sand making machine is lubricated with thin oil and automatic maintenance. When there is no oil flow and no oil pressure, it will stop automatically, and it is necessary to add regular oil regularly.

7. The starting sequence of VSI new sand making machine, discharge conveyor and feeding equipment is: discharging (1) → sand making machine (2) → feeding machine (3), the first step is to open the discharging conveyor first. Operation, the second open the sand making machine, note that the sand making machine must start at no load, after the sand making machine is running normally, the third step is to open the feeder and gradually supply the material gradually.

Back to top